Move your vacuum slowly across your hardwood floors so the wheels don’t scratch the surface. If you don’t have a hose attachment for your vacuum, switch the vacuum to the “hard floor” setting. This turns off the rotating beater bar that could scratch your hardwood.
Wipe up any big pools of water with a microfiber towel when you finish mopping since excess moisture could warp or damage the wood.
Try using a soft-bristled toothbrush to gently break apart the stuck-on debris on the surface.
You could use a plastic butter knife in a pinch if you don’t have a putty knife.
Twice a year, deep-clean your floors by mopping them with a solution of 1⁄4 cup (59 ml) of dish soap and 1 gallon (3. 8 L) of warm water.
It’s normal for gaps in your floorboard to be about the same thickness as a dime. If the cracks are any wider, then you should fill them. [7] X Research source
Filling in all the gaps in your flooring could take a day to finish completely, so it works best for small rooms. Apply the wood filler to your floor in sections starting in the far corner of your room and working towards the entrance. Wait until humid weather to fill in cracks in your hardwood floors. Doing it during dry weather could cause the wood filler to break and pop out when the wood swells again.
To match the color of your floor, stir a few drops of wood stain into the sawdust and epoxy before you apply it. Otherwise, wait until the epoxy hardens to stain your entire floor. It may take a full day to completely fill in the gaps in your floor with sawdust and epoxy.
Adding rope between your floorboards adds a more rustic look and keeps dirt and debris from getting trapped deeper. If you want it to blend in with your floorboards, stain or dye the rope before you install it. Just put the rope in a bucket and submerge it in your wood stain or dye until it turns the desired color. Let it dry completely before you use it.
This works best for floating hardwood floors and not if the floorboards are nailed down. Unfortunately, using a suction cup will not work for gaps between the sides of hardwood floorboards. Avoid using a standard plastic suction cup since it won’t stay attached when you tap it with a mallet.
