If the guy’s hair is very curly, you may have better results if you dry-cut his hair instead. Hair looks longer wet than dry, so cutting it dry will give you a better idea of how it will actually look in its dry state. You can also lightly spritz his hair with water to dampen it, if you prefer. Just make sure the hair is dry enough that it springs into its natural curl pattern. [1] X Research source
It may help to make a second horseshoe-shaped part running from the back of one ear, around the top of the head, and behind the other ear. Comb the hair in front of the part forward so it hangs down into the guy’s face, and comb the rest of the hair down to the sides and back.
To leave as much length as possible, just cut off about 1⁄2–1⁄4 in (1. 27–0. 64 cm) at the end of the hair. This will help remove any split ends. If you are cutting more than that, remember to take into consideration how much the hair will shrink when it dries, since hair stretches when it’s wet and looks longer. Curly hair will be much shorter dry than it is wet, but even straight hair will be somewhat shorter once it dries. It’s best to use a pair of shears intended for cutting hair. You can find these at any beauty supply store, as well as at many drugstores.
The length of the hair in the back will act as a guide to help you determine how long the rest of the hair should be.
Cutting the hair while it’s combed to the side will help the length blend into the back more evenly, but combing it to the front will allow you to check the accuracy.
After you make any changes, you may want to comb the hair to the side to make sure that the length still blends evenly into the back. If you want to, you can just stop here. Dry the hair, then check the length to make sure it’s even on both sides and there aren’t any pieces that need to be trimmed. However, to create a natural-looking style that looks more like it was done by a professional, add in a few subtle layers.
To find his natural part, comb the hair straight back, then push it forward a few times with your comb. Look for the place where the hair parts on its own.
When you see a small piece of hair fall from the bottom of your fingers, stop moving your fingers. This is the guide piece that will help you determine how long to cut the layers.
This technique creates soft, subtle layers, removing weight from the bottom of the hair.
If you can’t see the shorter hair, you probably picked up too much hair. Drop the section you’re holding and try again with a little less hair this time.
Each time you pick up a new section, include a little of the previous section. This will ensure you create consistent layers all the way around the hair. When you use the length of the previous section to guide the length of your next cut, this is called a “traveling guide. ”
Keep using the hair you’ve already cut as a guide as you layer the front and the sides of the hair. The length of the layers should be consistent all the way from the back to the front. Check a few sections against each other as you finish layering the hair. Pull the sections straight up, angled slightly, and out to the side to compare the length to make sure there aren’t any pieces that are longer than the rest.
At this point, you should only have to make minor adjustments. If there are any major sections that look too long or that seem to be very jagged, dampen the hair and start again.
